Last Trip Before Winter 2026 P1

We didn’t get everything done on time before the trip, but both Bronco’s did really well. Overnight near 30 degrees and the snow started the night before. This was exactly the same scenario a couple years ago in late October. I will post several blogs on the trip and preparation of the 1995 and 1996 Bronco’s we took.

Minor rust repair on the door seal flanges.

Metal repaired; POR15’d and painted; textured adhesive; new door rubber and front floor completed. Both sides required some repair.

Mild rust repair in the corner of the bed. Looks like something leaked into the corner, mixed with dirt and sat - slowly rusting away over the years.

Drip-Rails not great….. This is fairly normal on OBS Fords and especially where cold and wet in the spring, fall and winter.

Multiple roof seams underneath 30 year old, dried out factory drip rail sealer. Most of these leak to some extent and many times a windshield leak is falsely blamed.

What is going on underneath, is generally hidden. You can see one of the seams on the inside towards the roof.

Another common culprit that leaks into the interior top windshield trim and onto your lap. In the winter, the water freezes and slowly thaws from the cab heat and defroster, then steadily drips.

Better than new. Definitely sealed. New era professional seam sealers and products like SEM are really nice to work with. Anywhere water or air flows, I try to create smooth surfaces. It helps prevent mud and dirt from finding any surface to bond to as well.

Cleaned up behind the old windshield and discovered the two drains along the bottom behind the windshield trim were plugged with windshield sealer. In fact whomever installed the last windshield, partially covered the dash - vin plate too….? If you can do so without damaging your windshield trim, its a good idea to clean out behind the trim and regularly flush that area with water and air.

Rust and rough surfaces addressed

New glass; wipers and blades, trim painted and minor roof damage (tree branch strikes) repaired. Everything water tight now. So much better looking through new glass,

The air intake below the windshield, intakes and flows air and water (rain, snow and during washing). Generally, you will find a lot of debris, occasionally mummified mouse carcasses and nesting material. The factory foam styled seal and mastic does a better job holding debris, moisture, not really sealing anything and in this case, creating a physical dam preventing drainage. Really careless application to be honest. On both driver and passenger side, this void leads to a vertical void leading down to a rubberized drain that gets plugged or in some cases eaten by rodents crawling up into the space. The rust that can result can eventually corrode into the interior of the cab. Remember this void connects directly to your blower motor intake and AC / heater interior vents. Regular water and air to clean this area is a good idea. You can also see how smooth and unobstructed the “gutter” is now.

Next
Next

Part is Parts…..